Mellerware Iron 23455 User Manual

turbo glide  
s t e a m i r o n  
M o d e l :  
2 3 4 5 5  
1 7 0 0 W  
PLEASE READ ALL INSTRUCTIONS BEFORE USE  
 
23455_IM..indd  
1
5/21/2010 9:36:03 AM  
Safety advice and warnings  
in the appliance.  
- Connect the appliance to a base with an earthed  
- Read these instructions carefully before switching socket rated at 16 amps.  
the appliance on and keep them for future consul- - The appliance’s plug must fit into the mains  
tation. Failure to follow and observe these instruc- socket properly. Do not alter the plug. Do not use  
tions may result in an accident.  
plug adaptors.  
- Some parts of the iron have been lightly greased, - Do not use or store the appliance outdoors.  
so the iron may produce a little smoke when  
plugged in for the first time. This will stop after a Steam blast:  
short period of time.  
- Before using the iron for the first time, remove the Steam blasts give an extra steam jet to help remove  
plastic cover from the base and clean the base with tough creases.  
a soft cloth.  
- Select the maximum temperature*** on the tem-  
- Pure wool fabrics (100%) can be ironed with the perature gauge (H). Wait for the pilot light to go off  
iron set to steam. Preferably chose a high steam (I).  
setting and use a dry ironing cloth.  
- Press the steam blast button (B). Wait some  
seconds until vapour penetrates the fibres before  
pushing the button again. For optimum steam qual-  
ity, do not apply more than three successive blasts.  
Use or working environment:  
- Keep children and bystanders away when using The spray button has to be pressed repeatedly to  
this appliance.  
release the first spray.  
- The appliance must be used and placed on a flat,  
stable surface.  
Once you have finished using the appliance:  
Electrical safety:  
- Select the minimum position (MIN) using the ther-  
mostat control.  
- Fully unravel the power cable.  
- Always unplug the iron when not in use, even for  
a short period.  
- Unplug the appliance from the mains.  
Cleaning  
- Unplug the iron before filling or emptying the wa-  
ter tank.  
- Disconnect the appliance from the mains and al-  
- Do not leave the appliance out in the rain or ex- low to cool before undertaking any cleaning task.  
posed to moisture. If water gets into the appliance, - Clean the equipment with a damp cloth with a few  
this will increase the risk of electric shock.  
drops of washing-up liquid and then dry.  
- Do not use the appliance if it has fallen on the - Do not use solvents, or products with an acid or  
floor, if there are visible signs of damage or if it has base pH such as bleach, or abrasive products, for  
a leak.  
- Do not use the appliance near bathtubs, showers - Never submerge the appliance in water or any  
cleaning the appliance.  
or swimming pools.  
other liquid or put it under running water.  
- Keep the appliance well away from heat sources,  
oil, sharp edges or moving parts. Damaged or tan- Self-cleaning function:  
gled cables increase the risk of electric shock.  
- Do not use the appliance if the cable or plug is - It is important to self-clean the appliance at least  
damaged.  
- Ensure that the voltage indicated on the name- built-up minerals inside the iron.  
plate matches the mains voltage before plugging  
- Fill the tank to the top.  
once a month to remove calcium and any other  
 
23455_IM..indd  
3
5/21/2010 9:36:04 AM  
- Stand the iron upright and press the plug it in.  
- Turn the temperature gauge to the ***position.  
- Let the iron heat up until the pilot light goes off  
and comes back on again.  
- Unplug the iron and place it over the sink.  
- Push the self-cleaning button (D) and keep it  
pushed down.  
- Let the water flow out through the steam vents in  
the base, while lightly shaking the iron.  
- Release the self-cleaning button after a moment  
or when the tank has emptied and place the iron in  
an upright position.  
- Let the iron cool and then clean it.  
Anomalies and repair  
Go to an authorized Technical Support Service in  
the event of malfunctions. Do not try to dismantle or  
repair the iron yourself, as this may be dangerous.  
If the connection to the mains has been damaged,  
it must be replaced, and you should proceed as  
you would in the case of damage.  
Ecology and recyclability of the product  
- The materials of which the packaging of this ap-  
pliance consists are included in a collection, clas-  
sification and recycling system. Should you wish to  
dispose of them, use the appropriate public con-  
tainers for each type of material.  
- The product does not contain concentrations of  
substances which could be considered harmful to  
the environment.  
- Should you wish to dispose of the product once  
its working life has ended, take it to an authorised  
waste agent for the selective collection of waste  
from electric and electronic appliances.  
 
23455_IM..indd  
4
5/21/2010 9:36:04 AM  
 
23455_IM..indd  
5
5/21/2010 9:36:04 AM  
 
23455_IM..indd  
6
5/21/2010 9:36:04 AM  

KTI Networks TV Converter Box KCD 400 User Manual
LaCie Blu ray Player Slim Blu ray User Manual
Lantronix Switch 4092A IRIG B User Manual
Learning Resources Baby Toy Ler 2094 User Manual
Linksys Modem USBDSL1 User Manual
Maytag Refrigerator W10321477A User Manual
Maytag Washer YMHWE201 User Manual
McCulloch Lawn Mower M7053D User Manual
McCulloch Trimmer 250CXL User Manual
Meade Telescope TMB 80 User Manual